Digital display motorcycle battery charger 12V 2A new products smart automatic lead-acid battery charger for motorcycle car

The Digital display motorcycle battery charger 12V 2A new products lead-acid battery charger has designed highly reliable and meet international safety and electromagnetic compatibility requirements.

A:Input Characteristics:

   Input Voltage: 100-240Vac input AC voltage

   Input Frequency: 50Hz or 60Hz and single phase.

ac/50Hz(Typical full load)

B:Output Characteristics:

   Constant Charging Voltage: 14.4V   Float charge 13.8V

C:Charging Mode Digital display motorcycle battery charger 12V 2A new products lead-acid battery charger

   3 Stages, CC, CV, Trickle 

D:Safety Test for battery charger

   Hi-pot Test:15KVac 5mA 3 Seconds between input and output test

   Resistance:The battery charger insulation resistance shall be not less 30M ohms after application of 500Vdc/10mA for 3 Seconds

   Drop test: Height: The battery charger conform to BS EN60068-2-32:1993 TEST ED: free fall appendix B

E:Protection for battery charger

Over Voltage Protection   The battery charger will be auto recovered when faults remove

Over Current Protection   Charger output current does not exceed the set maximum battery charging current.

Over Short Circuit Protection  Battery charger output can be shorted without damage No odor, smoke, fire, plastic deformation, and excessive heal happen. The power shall be auto-recovery. (It will enter into normal condition when then the fault condition is removed)

Over reverse polarity Protection When the battery charger output line reversed after the charger will not work until the right user access only to start.

F:DC Connector Dimension:Digital display motorcycle battery charger 12V 2A new products lead-acid battery charger

Optional output connector: 3-port Inline, 3-pin XLR, Alligator clip, 3-port House, Coaxial etc.

Special plug: 4-pin XLR, 2-port Inline, 3-pin House, Polarized, 3-port House for Panterra and Grio, Polarized C7 etc